Rattler 310D Guia de Instalação descarregar pdf (Página 12)

step 1

Plug-in LED and Valet/Program switch

The LED and the Valet®/Program switch both plug into the

control module. The status LED plugs into the white two-pin

port, while the Valet®/Program switch should be plugged into

the blue two-pin port. The status LED and Valet®/Program

switch each fit into

–inch holes.

SSttaattuuss LLEEDD VVaalleett//PPrrooggrraamm SSwwiittcchh

When mounting the LED it will be necessary to locate an area on

the dash that is visible from all sides of the vehicle, and has at

least 1 inch of clearance behind the mounting area. It is recom-

mended that a factory "pop-out" be used for the LED mounting,

using a 9/32 drill bit drill a hole in the location selected, feed the

LED through the hole, press the LED firmly until it snaps into

place. Run the wires to the selected control module mounting

note: The security features consist only of ignition watch

where the horn will honk if the keyless system sees igni-

tion when locked and the security feature is turned on in

the features learned routine.

DIA-41

➜

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 70 71

Sem comentários

Rattler 310D Guia de Instalação Página 12